Session expiration Your session is going to expireClick here to extend

Budget (€) :

Small project <800

Posted on

1/2/17 10:09 PM

This project is completed

Someone on twago has already accepted this project. Find a project of your own, sign up today!

Post similar project now


Hi: We have been developing a new product (to be produced by plastic injection). Design is 98% ready, but our designer has become busy due to personal circumstances and is not available to complete the final changes.  I estimate no more than a few hours of work to get it finalized. See the attached image. In the original design, both parts marked in yellow were supposed to connect. This didn't work, so the change needed is to replace those connection points with just a hole through both parts, so I can connect them with a plastic rivet.  That's it.  I hope it was clear, otherwise please reach out to further explain.   Als het nodig is, kan ik ook Nederlands verstaan, maar het is makkeliker for mij in het Engels.